Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
Instrument Panel Lower Airbag Nut(1) - Remove[2x]
- Instrument Panel Lower Airbag - Driver Side(2) - Remove
- Disconnect the electrical connector.
With a flat bladed plastic trim tool, start at the front and work your way back to release the clips.
- Instrument Panel Outer Trim Cover - Left Side(1) - Remove
Disconnect the hood primary latch release cable end retainer from the hood primary latch release cable handle (1).
Instrument Panel Lower Trim Panel Insulator Retainer(1) - Remove
- Instrument Panel Insulator Bolt(2) - Remove[2x]
- Instrument Panel Insulator Nut(3) - Remove[2x]
- NOTE:
Use a plastic trim tool if necessary.
Release the tabs from the instrument panel lower trim panel insulator (1).
Instrument Panel Lower Trim Panel Insulator(1) - Remove
- Disconnect the front floor courtesy lamp electrical connector.
Move the steering column up so you can access the lower left corner of the instrument panel center trim pad (1).
- Start with a flat-bladed plastic trim tool in the lower left corner of the instrument panel center trim pad (1) and work your way clockwise.
- Instrument Panel Center Trim Pad(1) - Remove
- Disconnect the electrical connector.
Data Link Connector Bolt(1) - Remove[2x]
- Instrument Panel Knee Bolster Bolt(2) - Remove[3x]
Release the clips with a suitable tool.
- Disconnect and reposition harness as necessary.
- Clear the instrument panel knee bolster deflector studs when removing the instrument panel knee bolster (1).
Instrument Panel Accessory Bezel Bolt(1) - Remove[4x]
- Instrument Panel Switch Trim Plate(2) - Remove
Release the retaining tabs.
- Parking Brake Control Switch(1) - Remove