LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Traverse Premier, FWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Access System >> Diagnostic Information and Procedures >> DTC B324A or B3245 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: X2 @ X53A Fuse Block - Rear Body
  3. Connect a test lamp between the test points: Control circuit terminal 15 X2 & Ground
  4. Operate the component: S46B Liftgate Unlatch Switch - Pressed

    Verify the test lamp turns On and Off.

    • If the test lamp is always Off 
    1. Ignition/Vehicle - Off
    2. Test for infinite resistance between the test points: Control circuit terminal 8 X4 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    3. Test for less than 2 ohms between the test points: Control circuit terminal 8 X4 @ Control module harness & Control circuit terminal 15 X2 @ Fuse Block Harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Test or replace the component: K9 Body Control Module
    • If the test lamp is always On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical connector: X5 @ K9 Body Control Module
    3. Ignition - On / Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 8 X4 @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: K9 Body Control Module
    • Go to next step: If the test lamp turns On and Off 
  5. Connect a test lamp between the test points: Control circuit terminal 14 X2 & B+
  6. Operate the component: S46B Liftgate Unlatch Switch - Pressed

    Verify the test lamp turns On and Off.

    • If the test lamp is always Off 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical connector: X5 @ K9 Body Control Module
    3. Ignition - On / Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 20 X5 @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • Go to next step: If less than 1 V
    5. Ignition/Vehicle - Off
    6. Test for less than 2 ohms between the test points: Control circuit terminal 20 X5 @ Control module harness & Control circuit terminal 14 X2 @ Fuse Block Harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K9 Body Control Module
    • If the test lamp is always On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical connector: X5 @ K9 Body Control Module
    3. Test for infinite resistance between the test points: Control circuit terminal 20 X5 @ Control module harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K9 Body Control Module
    • Go to next step: If the test lamp turns On and Off 
  7. Replace the component: X53A Fuse Block - Rear Body
scientia non olet · About LEMON Manuals