Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify the scan tool parameter: Exterior Left Rear Door Handle Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Verify the scan tool parameter: Exterior Right Rear Door Handle Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component: B27LR Door Handle Switch - Left Rear Exterior - Pressed
Verify the scan tool parameter: Exterior Left Rear Door Handle Switch = Active
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component: B27RR Door Handle Switch - Right Rear Exterior - Pressed
Verify the scan tool parameter: Exterior Right Rear Door Handle Switch = Active
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- All OK.