Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Position the intermediate steering shaft (1) in the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Intermediate Steering Shaft (2) @ Steering Gear - Install

CAUTION:

Intermediate Steering Shaft Lower Bolt (1) - Install and tighten 55 N.m (40 lb ft)
1. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
2. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
Courtesy of GENERAL MOTORS COMPANY

Intermediate Steering Shaft (2) @ Steering Column - Install
Intermediate Steering Shaft Upper Bolt (1) - Install and tighten 42 N.m (31 lb ft)
1. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
2. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
Center the steering angle sensor. Steering Wheel Angle Sensor Centering