Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| CV Boot Clamp |
| Front Wheel Drive Shaft Retaining Ring |
| Front Wheel Drive Shaft Washer |
| Power Transfer Unit Half Shaft Seal |
| Rear Wheel Drive Shaft Retaining Ring |
| Rear Wheel Drive Shaft Seal |
| Retaining Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Shaft Nut | |
|
330 N.m (244 lb ft) |
|
loosen 45 degrees |
|
270 N.m (199 lb ft) |
| Rear Wheel Drive Shaft Nut | |
|
330 N.m (244 lb ft) |
|
loosen 45 degrees |
|
270 N.m (199 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Intermediate Shaft Bracket Bolt (Without F48) |
22 N.m (16 lb ft) |