LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Driver Assistance Systems) >> Diagnostic Information and Procedures >> DTC B13AD >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the connector at the S26 Hazard Warning Switch.
  2. Verify a test lamp illuminates between ground circuit terminal 5 and B+
    • If the test lamp does not illuminate 

      Repair the open/high resistance on circuit 1450 or the ground connection.

    • Go to next step: If the test lamp illuminates 
  3. Ignition ON.
  4. Verify the scan tool Lane Departure Warning Switch Status parameter is Off.
    • If the parameter is not Off 
    1. Test circuit 3153 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the K9 Body Control Module.
    • Go to next step: If the parameter is Off 
  5. Connect a 3 A fused jumper wire between signal circuit terminal 7 and ground.
  6. Verify the scan tool Lane Departure Warning Switch Status parameter is On.
    • If the parameter is not On 
    1. Test circuit 3153 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Replace the K9 Body Control Module.
    • Go to next step: If the parameter is On 
  7. Replace the S26 Hazard Warning Switch.
scientia non olet · About LEMON Manuals