Component Testing

Outside Rearview Mirror

1. Ignition OFF, disconnect the inline harness connector at the appropriate A9 Outside Rearview Mirror.
2. Install a 10 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the A9 Outside Rearview Mirror should perform the FOLD and UNFOLD functions.
   • If the function does not perform the FOLD and UNFOLD functions 

     Replace the A9 Outside Rearview Mirror.

   • Go to next step: If the function performs the FOLD and UNFOLD functions 
3. All OK