LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Data Communications - Repair Instructions >> Repair Instructions >> Serial Data Gateway Module Replacement >> Installation Procedure

Installation Procedure

  1. Serial Data Gateway Module (1) - Install
    GM5568576Courtesy of GENERAL MOTORS COMPANY
  2. Secure the retaining tabs.
  3. Connect the electrical connectors.
  4. Telematic Control Module (1) - Install
    GM5537641Courtesy of GENERAL MOTORS COMPANY
  5. Secure the retaining tabs.
  6. Connect the electrical connectors.
  7. Connect the accelerator pedal electrical connector.
  8. Floor Front Air Outlet Duct - Left Side (1) - Install
    GM5568663Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Upon installing the floor duct to the side of the HVAC case, it is necessary to verify duct opening is completely installed, surrounding the HVAC case outlet port. Failure to do so could result in the duct falling downward, with the potential to interfere with driver's legs and gas/brake pedal operation.

  9. Floor Front Air Outlet Duct Bolt (1) - Install and tighten - Fastener Specifications
    GM5002004Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  10. Instrument Panel Lower Trim Panel Insulator (1) - Install
    GM5515685Courtesy of GENERAL MOTORS COMPANY
  11. Instrument Panel Lower Insulator Retainer (1) - Install [2x]
    GM5515684Courtesy of GENERAL MOTORS COMPANY
  12. Perform the necessary programming and setup procedure:Control Module References
scientia non olet · About LEMON Manuals