Removal Procedure
- NOTE:
Left side shown, right side similar.
Front Seat- Left Side and Right Side (2) - Reposition [2x] - Front Seat Removal and Installation
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Lower Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
- NOTE:
Use a flat bladed plastic trim tool.
Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Remove
- Front Floor Console Extension Bolt (2) - Remove
- Move the front seat to access the retainers.
- Front Floor Console Extension Panel (3) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- NOTE:
You may have to slide the armrest back to better access the retainers.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Rear Trim Lower Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Rear Console Side Trim Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Lower Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
- NOTE:
Use a flat bladed plastic trim tool.
Move the front seat to access the retainers.
- Front Floor Console Extension Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Disconnect and reposition harness as necessary.
- Front Floor Rear Console Side Trim Panel (1) - Remove
- Slide the armrest compartment back.
Front Floor Console Storage Tray Bolt (1) - Remove [2x]
- Front Floor Console Armrest Hinge Clip (2) - Remove
Front Floor Console Armrest Pivot Pin (1) - Remove
- Front Floor Console Storage Tray Bolt (2) - Remove [2x]
Front Floor Console Stowage Tray (1) - Reposition
Pull up on the rear of the front floor console cup holder trim plate (1) to start to release the retainer clips and work your way forward.
- Disconnect the electrical connectors.
- Front Floor Console Cup Holder Trim Plate (1) - Remove
Wireless Charging System Module Bracket Bolt (1) - Remove [4x]
- Wireless Charging System Module (2) - Remove
Use a suitable tool.