Installation Procedure
- Generator (1) - Install
- Generator Bolt (1) - Install and tighten [2x] - Fastener SpecificationsCAUTION:NOTE:
The long generator bolt must be installed from the opening in the fan shroud.
- Position the accessory drive primary belt (4) on the belt idler pulley (2), fan and water pump pulley (3) and generator (1).
- Install EN-51767-2
Universal Stretchy Belt Installer (1) onto the crankshaft balancer.
- Position the accessory drive primary belt (2) on the crankshaft balancer.
- Slowly rotate the crankshaft balancer in a clockwise direction until the accessory drive primary belt (2) fully seats on the crankshaft balancer.
- Remove EN-51767-2 Universal Stretchy Belt Installer (1) from the crankshaft balancer.
- Inspect the accessory drive primary belt (1) for proper installation and alignment.
- Rotate the crankshaft balancer (1) and additional 360 degrees to ensure proper accessory drive primary belt installation.
- Starter Solenoid Cable (2) - Install
- Battery Positive Cable Nut (1) - Install and tighten - Fastener Specifications
- Electrical Connector (3) - Connect
- Position the right side fan blade/motor assembly into the fan shroud mounting location.
- Fan Blade Bolt-Right Side (2) - Install and tighten [3x] - Fastener Specifications
- Connect the right side fan motor assembly electrical connector (1).NOTE:
Some components not shown for graphic clarity.
- Air Cleaner Outlet Duct (3) - Install
- Air Cleaner Outlet Duct Clamp (2) - Tighten [2x]
- Positive Crankcase Ventilation Fresh Air Tube (1) - Connect - Plastic Collar Quick Connect Fitting Service
- Air Cleaner Outlet Duct Bracket Bolt (1) - Install and tighten - Fastener Specifications
- Install the engine wiring harness to the air cleaner outlet duct bracket.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)