Removal Procedure

Disable the SIR system. SIR Disabling and Enabling
Remove the front center seat. Front Center Seat Removal and Installation

Courtesy of GENERAL MOTORS COMPANY
Carefully pull the right side rear window lower garnish molding (1) forward around all edges then the middle of the part to disengage the clips from the sheet metal.
After all integral clips are disengaged, lift up and forward to clear the 2 rear end panel brackets that the right side rear window lower garnish molding (1) sits over.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.
Front Seat Belt Anchor Plate Tensioner Cover-Right Side (1) - Remove
Front Seat Belt Anchor Plate Tensioner Bolt-Right Side (2) - Remove

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.
Use a small flat bladed tool to open the right side trim panel bolt cap (1).
Body Lock Pillar Garnish Molding Bolt - Right Side (2) - Remove
Starting at the top and working down with a trim tool, grasp the right side body lock pillar garnish molding (3) and gently pull the panel away from the body to release the retainers.
Body Lock Pillar Garnish Molding-Right Side (3) - Remove
Route the seat belt webbing through the right side body lock pillar garnish molding (3).

Courtesy of GENERAL MOTORS COMPANY
Disconnect the electrical connector.
Release the retaining tabs.
Remote Function Actuator Module (1) - Remove