Circuit/System Testing

WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

Ignition ON and all vehicle systems OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left. It may take up to 2 min for all vehicle systems to power down.
Test for less than 10 Ω between the ground circuit terminal 7 and ground.
- If 10 Ω or greater
1. Ignition OFF.
2. Test for less than 2 Ω in the ground circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the ground circuit.
  - If less than 2 Ω, repair the open/high resistance in the ground connection.
- Go to next step: If less than 10 Ω
Verify the scan tool Lane Departure Warning Switch Status parameter is Open.
- If not Inactive
1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module.
2. Test for infinite resistance between the signal circuit terminal 12 and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance, replace the K109 Frontview Camera Module.
- Go to next step: If Inactive
Connect the harness connector at the S70L Steering Wheel Controls Switch - Left.
Verify the scan tool Lane Departure Warning Switch Status parameter changes between Open and Closed when pressing and releasing the lane departure warning switch.
- If not Active
1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
2. Test for less than 1 V between the signal circuit and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - Go to next step: If less than 1 V
3. Ignition OFF
4. Test for less than 2 Ω in the signal circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the K109 Frontview Camera Module.
- Go to next step: If Active
Test or replace the S70L Steering Wheel Controls Switch - Left.