Circuit/System Testing

WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left, ignition ON.
Verify a test lamp illuminates between the control circuit terminal 4 and ground.
- If the test lamp does not illuminate
1. Ignition OFF, disconnect the X1 harness connector at the K9 Body Control Module.
2. Test for less than 2 Ω in the control circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, refer to Interior Backlighting Malfunction .
- Go to next step: If the test lamp illuminates
Connect a test lamp between the control circuit terminal 5 and the control circuit terminal 4.
Verify the test lamp turns ON and OFF when commanding the Lane Departure Warning Indicator On and Off with a scan tool.
- If the test lamp is always OFF
1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
2. Test for less than 1 V between the voltage circuit and ground.
  - If 1 V or greater, repair the short to voltage on the circuit.
  - Go to next step: If less than 1 V
3. Ignition OFF.
4. Test for less than 2 Ω in the control circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the K109 Frontview Camera Module.
- If the test lamp is always ON
1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module.
2. Test for infinite resistance between the voltage circuit and ground.
  - If less than infinite resistance, repair the short to ground in the circuit.
  - If infinite resistance, replace the K109 Frontview Camera Module.
- Go to next step: If the test lamp turns ON and OFF
Test or replace the S70L Steering Wheel Controls Switch - Left.