LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Silverado 2500 HD Custom, 4D Pickup Extra Cab, 4WD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K69 Transfer Case Control Module: Programming and Setup (NQH) >> Programming a New Control Module - Old Module Does Not Communicate

Programming a New Control Module - Old Module Does Not Communicate

  1. Replace the component:K69 Transfer Case Control Module
  2. Ignition - On / Vehicle - In Service Mode
  3. Access SPS and follow the on-screen instructions for the control module:K69 Transfer Case Control Module
  4. Perform the SPS function:K69 Transfer Case Control Module - Programming
  5. Perform the SPS function:K69 Transfer Case Control Module - Setup

    Enter the Transfer Case Clutch Identifier

    Refer to:Transfer Case Identification

  6. Clear DTCs.
  7. Perform the scan tool function:Range Actuator Learn

    Refer to:Transfer Case Range Actuator Learn

scientia non olet · About LEMON Manuals