Circuit/System Verification

Ignition - On / Vehicle - In Service Mode
A DTC may set if control module K9 is not programmed after replacing control module K9.
- If the DTC sets = K9 Body Control Module - Programmed
  Perform the SPS function: Z1 Immobilizer Function - K9 Body Control Module Refer to Immobilizer System Component Programming
- Go to next step: If the DTC sets K9 Body Control Module - Programmed
Verify DTC B3902 is not set.
- If DTC B3902 is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If DTC B3902 is not set
Perform the SPS function: Z1 Immobilizer Function - K9 Body Control Module Refer to Immobilizer System Component Programming
Verify DTC B389A is not set.
- If DTC B389A is set
  Replace the component: K9 Body Control Module
- Go to next step: If DTC B389A is not set
All OK.