Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Drive Motor Generator Control Module Cooling Outlet Hose(1) - Install
Clamp(2) - Install - Hose Clamp Replacement Guidelines - Spring Type
Front Wheelhouse Liner Replacement (Left Side)Front Wheelhouse Liner Replacement (Right Side) - Install
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Install a NEW seal.(2)

CAUTION:

Drive Motor Generator Control Module Cooling Outlet Hose Bolt(1) - Install and tighten[2x]9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Coolant Hose(1) - Install
Clamp(2)Install - Hose Clamp Replacement Guidelines - Spring Type
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector(1, 2) - Connect
Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling