Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| 300 - Volt Battery Positive and Negative Cable Fastener | 9N.m (80 lb in) |
| 300 - Volt Battery Positive and Negative Cable Retainer Fastener | 9N.m (80 lb in) |
| Auxiliary Generator Battery Jumper Cable Bolt | 9N.m (80 lb in) |
| Auxiliary Generator Battery Jumper Cable Fastener | 9N.m (80 lb in) |
| Battery Cooling Plate Hose Clamp | 2.1N.m (19 lb in) |
| Battery Hold Down Retainer Fastener | 9N.m (80 lb in) |
| Battery Tray Front Brace Fastener | 9N.m (80 lb in) |
| Battery Tray Front-Rear Brace Fastener | 9N.m (80 lb in) |
| Cell Battery Cooling Manifold Inlet Hose Clamp | 2.5N.m (22 lb in) |
| Cell Battery Cooling Manifold Outlet Hose Clamp | 2.5N.m (22 lb in) |
| Drive Motor Battery Tray Bolt | 58N.m (43 lb ft) |
| Drive Motor Battery Tray Bolt (Rear Cross-Bar) | 22N.m (16 lb ft) |
| Engine Wiring Harness Ground Nut | 9N.m (80 lb in) |
| Fuse Block Cover Fastener | 2.5N.m (22 lb in) |
| Generator Battery Current Sensor Fastener | 9N.m (80 lb in) |
| Ground Cable Nut | 9N.m (80 lb in) |
| Ground Strap Nut | 9N.m (80 lb in) |
| High Voltage Battery Cover Fastener | 9N.m (80 lb in) |
| High Voltage Battery High Voltage Manual Disconnect Connector Fastener | 9N.m (80 lb in) |
| High Voltage Battery Positive Cable Fastener | 9N.m (80 lb in) |
| High Voltage Battery Positive Cable Bracket Fastener | 9N.m (80 lb in) |
| Inspection Plug Fastener | 9N.m (80 lb in) |
| Pass-Through Grommet Fastener | 9N.m (80 lb in) |
| Power Inverter Module Connector Cover Bolt | 9N.m (80 lb in) |
| Power Inverter Module Connector Cover Nut | 9N.m (80 lb in) |
| Power Inverter Module High Voltage Cable Cover Bolt | 9N.m (80 lb in) |
| T6 Power Inverter Module Cable Retainer Fastener | 9N.m (80 lb in) |