LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Volt Premier >> Repair and Diagnosis (Single Page) >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Controls >> Repair Instructions >> Accessory DC Power Control Module Replacement >> Installation Procedure

Installation Procedure

    CAUTION:

    Ensure that all electrical connections are made before the hoses are connected, and the cooling system is filled. Failure to do this may result in damage to the electrical connectors or components. Any damaged electrical connectors or components must be replaced.

  1. GM4091469Courtesy of GENERAL MOTORS COMPANY

    Install the accessory dc power control module (9).

    2. CAUTION:

    Refer to: Fastener Caution .

  2. Install the accessory dc power control module bolt (8) and tighten to 22 N. m (16 lb ft).
  3. Install 2 the accessory dc power control module nuts (1) and tighten to 22 N. m (16 lb ft).
  4. Install the battery positive and negative cable nuts (B+ APM Module to Battery Fuse Block) (7) and tighten to 22 N. m (16 lb ft).
  5. Install the battery positive and negative cable nut (APM ground cable) (6) and tighten to 22 N. m (16 lb ft).
  6. Electrical Connector(2, 4) - Connect
  7. Coolant Hose - Install[2x]
  8. Clamp(3, 5) - Install[2x] - BO-38185  pliers
  9. Fill the cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
  10. Battery Negative Cable Disconnection and Connection - Connect
  11. Rear Compartment Floor Stowage Trim Compartment Replacement - Install
  12. High Voltage Enabling
scientia non olet · About LEMON Manuals