LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Volt LT >> Repair and Diagnosis >> Electrical >> Body Electrical >> Plug-In Charging >> Diagnostic Information and Procedures >> DTC P0D3E-P0D40 >> Circuit/System Verification

Circuit/System Verification

  1. Drive the vehicle above 6 km/h (4 mph).
  2. Vehicle OFF. Connect the vehicle to an AC supply to begin charging.
  3. Vehicle in Service Mode.
  4. Verify that P0D3E, P0D3F, or P0D40 is not set.
    • If any of the DTCs are set 

      Refer to Circuit/System Testing.

    • Go to next step: If none of the DTCs are set 
  5. All OK.