LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Trax LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Rear Drive Axle) >> Repair Instructions >> Rear Wheel Drive Module Differential Clutch Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2771708

    Position the differential clutch control module (2) on the differential carrier.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the mounting screws (1) to the differential carrier and tighten to 22 N.m (16 lb ft).
  3. Connect the electrical connector (3) to the differential carrier.
  4. GM2771660

    Secure the differential control module to the differential clutch using the electrical tie (1).

  5. GM2769927

    Connect the electrical connector (3).

  6. Install the wiring harness retainers (2) and (1) to the differential clutch control module.
  7. GM2771626

    Position the shield (2) on the differential clutch control module (1).

  8. Install the 2 mounting screws (4) and tighten to 11 N.m (97 lb in).
  9. Install the mounting nut (3) and tighten to 10 N.m (89 lb in).
  10. Install the propeller shaft to the rear differential.
  11. Remove the support and lower the vehicle.
  12. Reprogram the differential clutch control module. K47 Rear Differential Clutch Control Module: Programming and Setup .
scientia non olet · About LEMON Manuals