Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Index the wider male heater and air conditioning mode control cam gear tooth, to the wider female heater and air conditioning mode control cam gear tooth indicated by the arrows.
Heater and Air Conditioning Mode Control Cam(1) - Install[2x]
Heater and Air Conditioning Evaporator and Blower Module Bracket(1) - Install
- CAUTION:
Refer to Fastener Caution .
Heater and Air Conditioning Evaporator and Blower Module Bracket Bolt(1) - Install and tighten[4x]1.5 N.m (13 lb in)
- Connect the electrical connector.
Mode Control Cam Actuator(2) - Install
- Mode Control Cam Actuator Bolt(1) - Install and tighten[2x]1.5 N.m (13 lb in)
Air Inlet Valve Actuator(2) - Left Side - Install - Air Inlet Valve Actuator Replacement - Left Side (With CJ2)
- Steering Column Assembly - Install - Steering Column Replacement (Buick, Mexico, NJ1, With BTM, With N06)Steering Column Replacement (Buick, Canada/United States, NJ1, With BTM, Without N06)Steering Column Replacement (Chevrolet, Mexico, NJ1, With BTM, With N06)Steering Column Replacement (Chevrolet, Canada/United States, NJ1, With BTM, Without N06)Steering Column Replacement (Chevrolet, Canada/United States, NJ1, Without BTM, Without N06)Steering Column Replacement (Chevrolet, Mexico, NJ1, Without BTM, Without N06)Steering Column Replacement (Mexico, N40)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
- Clear the DTCs from the heater and air conditioning remote control module.
- Perform the actuator calibration procedure. Actuator Recalibration