LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Trax LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (HVAC System - Automatic) >> Repair Instructions >> Mode Control Cam Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4421242
    CAUTION:

    Refer to Fastener Caution .

    Connect the electrical connector.

  2. Mode Control Cam Actuator(2) - Install
  3. Mode Control Cam Actuator Bolt(1) - Install and tighten[2x]1.5 N.m (13 lb in)
  4. Steering Column Assembly - Install - Steering Column Replacement (Buick, Mexico, NJ1, With BTM, With N06)Steering Column Replacement (Buick, Canada/United States, NJ1, With BTM, Without N06)Steering Column Replacement (Chevrolet, Mexico, NJ1, With BTM, With N06)Steering Column Replacement (Chevrolet, Canada/United States, NJ1, With BTM, Without N06)Steering Column Replacement (Chevrolet, Canada/United States, NJ1, Without BTM, Without N06)Steering Column Replacement (Chevrolet, Mexico, NJ1, Without BTM, Without N06)Steering Column Replacement (Mexico, N40)
  5. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9)Battery Negative Cable Disconnection and Connection (with KL9)
  6. Clear the DTCs from the heater and air conditioning remote control module.
  7. Perform the actuator calibration procedure. Actuator Recalibration 
scientia non olet · About LEMON Manuals