LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Trax LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (12 V Starting And Charging System) >> Repair Instructions >> Generator Replacement (LE2) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4169707

    Generator(4) - Install

    2. CAUTION:

    Refer to Fastener Caution

  2. Generator Mounting Stud(3) Install and tighten 9 N.m (80 lb in)
  3. Generator Mounting Nut(2) Install and tighten 22 N.m (16 lb ft) 22 N.m (16 lb ft)
  4. Generator Bolt(1) Install and tighten[2X] 22 N.m (16 lb ft) 22 N.m (16 lb ft)
  5. GM4169704

    Electrical Connector(4) - Connect

  6. Battery Positive Cable(2) - Install
  7. Battery Positive Cable Nut(2) - Install and tighten 17 N.m (13 lb ft)
  8. Generator Terminal Protective Boot(1) - Install
  9. Drive Belt - Install Drive Belt Replacement
  10. Front Wheel Drive Shaft-Right Side - Front Wheel Drive Shaft Replacement - Right Side (AWD)Front Wheel Drive Shaft Replacement - Right Side (FWD)
  11. Front Compartment Front Center Insulator - Install Front Compartment Front Center Insulator Replacement
  12. Lower the vehicle.
  13. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) 
scientia non olet · About LEMON Manuals