LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Trax LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (12 V Starting And Charging System) >> Repair Instructions >> Battery Monitor Module Replacement (KL9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4098031

    Battery Monitor Module(2) - Install

  2. Battery Negative Post Clamp Nut(1) - Tighten 4.5 N.m (40 lb in)
  3. GM4098029
    CAUTION:

    Refer to Fastener Caution .

    Use an open ended wrench to hold the battery sensor ground tab, while tightening the battery negative cable nut.

  4. Battery Negative Cable(2) - Install
  5. Battery Negative Cable Nut(3) - Install and tighten 11 N.m (97 lb in)
  6. GM4098026

    Connect the electrical connector.(1)

  7. Program all of the customer's radio station presets and set the radio clock to the current time.
  8. Perform the battery sensor learn procedure. Battery Sensor Module Learn 
scientia non olet · About LEMON Manuals