LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Trax LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Disc Brake System) >> Repair Instructions >> Rear Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2771553

    Install the rear brake caliper bracket (1).

  2. GM2771551
    CAUTION:

    Refer to Fastener Caution .

    Install new brake caliper bracket bolts (1) and tighten to 100 N.m (74 lb ft).

  3. GM2771549

    Install the upper brake caliper guide pin (1).

    4. NOTE:

    The lower brake caliper guide pin is equipped with a bushing and must be installed in the same location.

  4. Install the lower brake caliper guide pin (2).
  5. GM2771545

    Install the upper and lower brake pad springs (1).

  6. GM2771543

    Install the outer brake pad (1).

    7. NOTE:

    The inner brake pad is equipped with the wear sensor.

  7. Install the inner brake pad (2).
  8. Install the rear brake caliper. Refer to Rear Brake Caliper Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals