Installation Procedure
Install the connector (1) to the oil pan heater (2), if equipped.
- CAUTION:
Refer to Fastener Caution .
Install the battery positive cable (3) to the generator and tighten the fastener (2) to 17 N.m (13 lb ft).
- Install the protective cover (1).
Install the battery positive cable terminal (1) to the starter solenoid and tighten the fastener (2) to 13 N.m (115 lb in).
- Install the battery negative cable (5) to the starter mounting stud and tighten the fastener (3) to 13 N.m (115 lb in).
- Install the battery positive and negative cable retainer (4) to the transmission bracket.
- Install the transfer case, if equipped. Refer to Transfer Case Replacement .
- Install the drivetrain and front suspension frame transmission protector. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
Install the battery negative cable (2) to the frame rail stud and tighten the fastener (1) to 9 N.m (80 lb in).
- Install the battery tray. Refer to Battery Tray Replacement .
Install the battery positive cable (2) to the battery fuse block and tighten the fastener (1) to 12 N.m (106 lb in).
- Install the transfer case, if equipped. Refer to Transfer Case Replacement .
Install the battery fuse block cover (1) and install the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) .