Removal Procedure
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Clean the area surrounding the EBCM/BPMV assembly of any accumulated dirt and debris.
- Disconnect the EBCM electrical connector.
Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Left Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Bracket Bolt (1) - Remove [3x]
Brake Pressure Modulator Valve Assembly (1) - Remove
Brake Pressure Modulator Valve Bolt (1) - Remove
Brake Pressure Modulator Valve Bracket (1) - Remove
Electronic Brake Control Module Bolt (1) - Remove [4x]
Brake Pressure Modulator Valve (1) - Remove
The area around the electronic brake control module (EBCM) and brake pressure modulator valve (BPMV) assembly must be free from loose dirt to prevent contamination of disassembled ABS components.