LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B127B: Rearview Camera Video Signal >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the high resistance condition due to terminal fretting corrosion.
  1. Ignition ON.
  2. Verify the rearview camera has no debris on the lens and that the bezel and bezel seal are not damaged.
    • If debris is found on the lens 

      Clean the lens. If the lens, bezel or bezel seal are damaged, replace as necessary.

    • If no debris on the lens 
  3. Engine running, parking brake applied and transmission in R.
  4. Verify the backup lamps are illuminated.
    • If the backup lamps are illuminated 
  5. Engine running, parking brake applied and transmission in R.
  6. Verify a clear rear vision image is displayed on the P17 Info Display Module.
    • If a clear image is not displayed 

      Refer to Circuit/System Testing.

    • If a clear image is displayed 
  7. All OK.
scientia non olet · About LEMON Manuals