LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Power Steering System) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2968098

    Apply threadlock compound to the threads of the inner tie rod (1).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the steering linkage inner rod (1), using the CH-50751  wrench and tighten to 105 N.m (77 lb ft).
  3. Install the steering gear boot. Refer to Steering Gear Boot Replacement .
  4. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Measure the wheel alignment. Refer to Wheel Alignment Measurement .
  7. Adjust front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
  8. Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering .
scientia non olet · About LEMON Manuals