Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

If installing a new brake rotor, clean the friction surfaces of the brake rotor with denatured alcohol or equivalent.
Using the CH-42450-A Wheel Hub Resurfacing Kit, thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
Using the CH-41013 Rotor Resurfacing Kit, thoroughly clean any rust or corrosion from the mating surface of the rotor to the hub/axle flange.
Courtesy of GENERAL MOTORS COMPANY

Install the brake rotor (1).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the brake rotor bolt (1) and tighten to 9 N.m (80 lb in)
Position the brake caliper and bracket assembly over the brake rotor and to the steering knuckle.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not reuse the brake caliper bracket bolts.

Install 2 new brake caliper bracket bolts (1) and tighten to 100 N.m (74 lb ft).
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing .