Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.
Install the brake caliper bracket (1).
- CAUTION:
Refer to Fastener Caution .
Install 2 new brake caliper bracket bolts (1) and tighten to 100 N.m (74 lb ft).
Install the brake pad springs (1).
Install the 2 brake caliper guide pin seals.
- Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper bracket.
- Install the upper brake caliper guide pin (1).
- Install the lower brake caliper guide pin (2).
- Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper guide pins.
- NOTE:
Note the location of the wear sensor for correct installation.
Install the inner brake pad (1).
- Install the outer brake pad (2).
- Position the brake caliper over the brake pads and to the caliper bracket.
Using a backup wrench to hold the brake caliper guide pin stationary, install the brake caliper guide pin bolts (1) and tighten to 40 N.m (30 lb ft).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
NOTE:
The upper brake caliper guide pin is equipped with a bushing and must be installed in the same location.