LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Sonic LS, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

  1. If you are replacing the steering column or the intermediate steering shaft, copy the match marks from the old parts to the new parts.
  2. GM2511152Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Do NOT allow the wiring harness to be pinched between the motor/module assembly and the steering column during installation. A pinched harness will cause diagnostic trouble codes to be set and may require replacement of the steering column.

    Position the steering column assembly (1) in the vehicle.

  3. Align the match marks and connect the intermediate steering shaft to the steering gear pinion shaft.
  4. GM2511151Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    In order to ensure the intended function of the steering column in a vehicle during a crash and in order to avoid personal injury to the driver, perform the following:

    • Tighten the steering column lower fasteners before you tighten the steering column upper fasteners. Failure to do this can damage the steering column.
    • Tighten the steering column fasteners to the specified torque. Overtightening the upper steering column fasteners could affect the steering column collapse.
    CAUTION:

    Ensure all fasteners are securely seated before applying needed torque. Failure to do so may result in component damage or malfunctioning of steering column.

    Install, but do not tighten, the 2 steering column upper support bracket nuts (1, 2).

  5. GM2511150Courtesy of GENERAL MOTORS COMPANY

    Install, but do not tighten, the 2 steering column lower support bracket bolts (1, 2).

  6. GM2511142Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the intermediate steering shaft lower bolt (2) and tighten to 49 N.m (36 lb ft).

  7. Tighten the 2 steering column lower support bracket bolts to 22 N.m (16 lb ft).
  8. Tighten the 2 steering column upper support bracket nuts to 22 N.m (16 lb ft).
  9. Connect any electrical connectors as necessary.
  10. Install the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side (LHD) .
  11. Install the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement .
  12. Install the upper trim cover and the lower trim cover to the steering column. Refer to Steering Column Lower Trim Cover Replacement .
  13. Setup the power steering control module. Refer to Control Module References .
  14. Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering .
scientia non olet · About LEMON Manuals