Installation Procedure

Plug the wheel speed sensor bore to prevent debris from entering the wheel hub and bearing.
Clean the mounting surface on the wheel hub to remove any corrosion and debris.
Apply a light coat of wheel speed anti-corrosion grease to the wheel speed sensor and mounting pad on the wheel hub and bearing assembly. Adhesives, Fluids, Lubricants, and Sealers
Remove the plug from the wheel speed sensor bore.
Courtesy of GENERAL MOTORS COMPANY

Wheel Speed Sensor(1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Wheel Speed Sensor Bolt(1) - Install and tighten18 N.m (13 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Clip(1) - Secure
Courtesy of GENERAL MOTORS COMPANY

Clip(1) - Secure
Courtesy of GENERAL MOTORS COMPANY

Clip(1) - Secure
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector(1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Front Brake Rotor(1) - Install - Front Brake Rotor Replacement (JH6) , or Front Brake Rotor Replacement (JH9)
Install the tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels) , or Tire and Wheel Removal and Installation (With Dual Rear Wheels)
Perform the diagnostic system check. Diagnostic System Check - Vehicle