Circuit/System Verification

• If a related DTC is set 

  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle

• Go to next step: If a related DTC is not set 

• If not the specified state 

  Refer to: Circuit/System Testing - Test 1

• Go to next step: If the specified state 

Verify the scan tool parameter: Stop/Start Select Switch = Active

• If not the specified state 

  Refer to: Circuit/System Testing - Test 1

• Go to next step: If the specified state 

Verify the component activates: Stop/Start Select Switch Indicator

• If the component does not activate 

  Refer to: Circuit/System Testing - Test 2

• Go to next step: If the component activates 

• Battery Sensor Module Battery State Information = Available
• Battery Sensor Module Reset Occurred - Using Estimated State of Charge = No

• If not the specified state 

1. Disconnect & Connect - Battery Negative Cable
NOTE:

Allowing the vehicle to sit undisturbed for 3 h will automatically perform a Battery Sensor Learn upon the next engine cranking event. This will allow the battery state of charge to be relearned.

2. Wait for greater than 180 min.
3. Road Test - Vehicle

   Verify the correct operation: Stop/Start System

   • If a condition exists

     Refer to: Stop/Start Disable, Inhibit, and Restart Reasons 

   • Go to next step: If no condition exists
4. All OK.

• Go to next step: If the specified state 

Verify the correct operation: Stop/Start System

• If a condition exists 

  Refer to: Stop/Start Disable, Inhibit, and Restart Reasons 

• Go to next step: If no condition exists 

• If a condition exists 

  Refer to: Circuit/System Testing - Test 3

• Go to next step: If no condition exists