LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Cruze L >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Access System >> Diagnostic Information and Procedures >> DTC B3265 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: X4 @ K9 Body Control Module
  3. Ignition - On/Vehicle - In Service Mode
  4. Test for less than 1 V between the test points: Control circuit terminal 10 X4 @ Control module harness & Ground
    • If 1 V or greater 

      Replace the component: X51A Fuse Block - Instrument Panel

    • Go to next step: If less than 1 V 
  5. Momentarily connect a 3 A fused jumper wire between the test points: Control circuit terminal 10 X4 & B+
  6. Verify a click can be heard or felt at the component when the scan tool control function was commanded: M40 Rear Compartment Lid Latch
    • If a click cannot be heard or felt 

      Replace the component: X51A Fuse Block - Instrument Panel

    • Go to next step: If a click can be heard or felt 
  7. Replace the component: K9 Body Control Module
scientia non olet · About LEMON Manuals