Installation Procedure
- Inspect the inside of the ignition coil boot for a thin, even coat of dielectric grease. If there is no grease present or additional grease is necessary, continue to the next step.
- Apply a thin coating of dielectric grease to the inside of the ignition coil boot up to a depth of 15 mm (0.60 in) from the end of the boot. Adhesives, Fluids, Lubricants, and Sealers
- Remove any excess dielectric grease from around the end of the ignition coil boot and ensure there is not an excessive amount within the boot.
Ignition Coil (2) - Install [4x]
- Ignition Coil Bolt (1) - Install and tighten [4x] 10 N.m (89 lb in)
Ignition Coil Electrical Connector (1) - Connect [4x]
- Intake Manifold Cover - Install - Intake Manifold Cover Replacement
CAUTION:
Refer to Fastener Caution .