Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.
- Using a suitable jack stand support the driveline torque tube.
Install the driveline torque tube (1) and the NEW gasket (2) to the differential carrier.
- NOTE:
The driveline torque tube and differential carrier are balanced as an assembly. When re-using the original driveline torque tube it should be re-installed in the same position in relation the pinion splines.
Ensure the driveline torque tube and pinion spline marks are aligned (1).
- CAUTION:
Refer to Fastener Caution .
Prepare the bolt for installation as follows:
- Remove all traces of the adhesive patch from the bolt and the mating threads using the appropriate tools.
- Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolts. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the bolt.
- Install and hand tighten the driveline torque tube bolts (1) before torquing to specifications.
- Tighten the driveline torque tube bolts (1) to 55 N.m (41 lb ft).
Install the differential carrier insulator bolt (1) and tighten to 160 N.m (118 lb ft).
Install the propeller shaft assembly (1). Two-Piece Propeller Shaft Replacement
- Remove the support and lower the vehicle.