Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.

Prior to installing the differential carrier. Review the clutch control module programming information. It may be necessary to record the rear differential clutch service calibration values found stamped in the differential housing.
Courtesy of GENERAL MOTORS COMPANY

Position the differential carrier (1) in the vehicle.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the differential carrier rear bolts (1).

Tighten

100 N.m (74 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Install the differential carrier insulator bolt (1). Driveline Torque Tube Replacement
Courtesy of GENERAL MOTORS COMPANY

Reconnect the electrical connector (1) for the differential control module.
Install the propeller shaft. Two-Piece Propeller Shaft Replacement
Refill the differential carrier. Rear Axle Lubricant Replacement
Install the rear wheel drive shafts
- Rear Wheel Drive Shaft Replacement - Left Side
- Rear Wheel Drive Shaft Replacement - Right Side
Remove the support and lower the vehicle.
K47 Rear Differential Clutch Control Module - Program - Control Module References