Installation Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.
Position the intermediate steering shaft (1) in the vehicle.
Intermediate Steering Shaft (2) @ Steering Gear - Install
- Intermediate Steering Shaft Lower Bolt (1) - Install and tighten 55 N.m (40 lb ft)
- Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers
Intermediate Steering Shaft (2) @ Steering Column - Install
- Intermediate Steering Shaft Upper Bolt (1) - Install and tighten 42 N.m (31 lb ft)
- Clean the threads of the bolt and mating threads with denatured alcohol or equivalent and allow to dry.
- Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers
- Center the steering angle sensor. Steering Wheel Angle Sensor Centering
CAUTION:
Refer to Fastener Caution .