Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.

Windshield Wiper Switch

Ignition OFF, disconnect the harness connector at the S82 Windshield Wiper/Washer Switch.
Test for infinite resistance between the signal terminal 2 and the low reference terminal 1 with the high speed switch in the open position.
- If less than infinite resistance
  Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If infinite resistance
Test for less than 2 Ω between the signal circuit terminal 2 and the low reference circuit terminal 1 with the high speed switch in the closed position.
- If 2 Ω or greater
  Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If less than 2 Ω
Test for infinite resistance between the signal terminal 3 and the low reference terminal 1 with the low speed switch in the open position.
- If less than infinite resistance
  Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If infinite resistance
Test for the resistance values listed below between the signal circuit terminal 3 and the low reference circuit terminal 1 by cycling the switch between Delay 1 and Delay 5.
- Delay 1 : 7.50-8.00kΩ
- Delay 2 : 1.29-1.34kΩ
- Delay 3 : 1.95-2.00kΩ
- Delay 4 : 2.78-2.82kΩ
- Delay 5 :3.84-3.90kΩ
- If not within the resistance values listed
  Replace the S82 Windshield Wiper/Washer Switch.
- Go to next step: If within the resistance values listed
All OK