Removal Procedure
WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.
- Prior to removing the rear differential carrier assembly. Review the clutch control module programming information. It may be necessary to prepare the control module for removal using the SPS programming tool prior to lowering the carrier assembly.
- For programming information, refer to Control Module References .
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Drain the differential carrier. Rear Axle Lubricant Replacement
- Remove the rear wheel drive shafts.
- Remove the propeller shaft. Two-Piece Propeller Shaft Replacement
Disconnect the electrical connector (1) from the differential control module.
Remove the differential carrier insulator bolt (1).
- Support the driveline torque tube with a jack stand.
- Support the differential carrier with a transmission jack.
Remove the differential carrier rear bolts (1).
With the aide of an assistant, remove the differential carrier (1) from the vehicle.