Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Battery (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Battery Hold Down Retainer (4) - Install

CAUTION:

Refer to Fastener Caution

Battery Hold Down Bolt (3) - Install and tighten 22 N.m (16 lb ft)
Battery Hold Down Retainer (1) - Install
Battery Hold Down Retainer Bolt (2) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Fuse Block (2) - Install
Retaining Tab (1) - Engage [2x]
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Post Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
Retainer (2) - Engage
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable (1) - Install [2x]
Battery Positive Cable (2) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Fuse Block Nut (2)@Battery Fuse Block (3) - Install and tighten [2x] 16 N.m (12 lb ft)
Fuse Block Nut (1)@Battery Fuse Block (3) - Install and tighten [2x] 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Close the battery fuse block cover. (2)
Retainer (1) - Engage
Install the engine control module bracket along with the engine control module to the battery tray. Engine Control Module Bracket Replacement
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (KL9)