Installation Procedure

Apply a light coat of wheel speed sensor anti-corrosion grease to the wheel speed sensor and mounting pad on the wheel hub and bearing assembly. Refer to Adhesives, Fluids, Lubricants and Sealers
Install Wheel Speed Sensor (1)

Fig 1: Wheel Speed Sensor
Courtesy of GENERAL MOTORS COMPANY
Install and tighten Wheel Speed Sensor Bolt (1) to 13 N.m (115 lb in)

Fig 2: Wheel Speed Sensor Bolt
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution
Secure Wheel Speed Sensor Harness Clip (1)

Fig 3: Wheel Speed Sensor Harness Clip
Courtesy of GENERAL MOTORS COMPANY
Secure Wheel Speed Sensor Harness Clip (1)

Fig 4: Wheel Speed Sensor Harness Clip
Courtesy of GENERAL MOTORS COMPANY
Secure Wheel Speed Sensor Harness Clip (1)

Fig 5: Wheel Speed Sensor Harness Clips
Courtesy of GENERAL MOTORS COMPANY
Secure Wheel Speed Sensor Harness Clip (2)
Connect Wheel Speed Sensor Electrical Connector
Perform the vehicle diagnostic system check. Refer to Diagnostic System Check - Vehicle