Installation Procedure
Position the junction block base (2) to the inner wheelhouse stud.
- Install the junction block base nut (1) and tighten to 9 N.m (80 lb in).
Install the junction block (2) to the base.
- Install the junction block bolts (1) and tighten to 9 N.m (80 lb in).
Position the positive battery cable to the junction block.
- Install the positive battery cable nut (1) and tighten to 5 N.m (44 lb in).
Install the junction block cover (1).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .