LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Column, Nuts And Bolts
    GM3274368Courtesy of GENERAL MOTORS COMPANY
  1. Position the steering column (3) in the vehicle.
  2. Start the steering column nuts (1) but do NOT tighten.
  3. Start the steering column bolts (2) but do NOT tighten.
  4. Fig 2: Steering Column Nut And Bolt Tightening Sequence
    GM5034403Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  5. Steering Column Nut (2) - Tighten in sequence (Qty: 2) 27 N.m (20 lb ft)
  6. Steering Column Bolt (2) - Tighten in sequence (Qty: 2) 27 N.m (20 lb ft)
  7. Fig 3: Steering Column, Steering Wheel And Vehicle Body Wiring Harness Connectors
    GM3385200Courtesy of GENERAL MOTORS COMPANY
  8. Connect the steering column wiring harness connector (4) to the vehicle body wiring harness on top of the body control module bracket.

    Ensure the cam lock on the connector is secured completely.

  9. Secure the steering wheel airbag wiring harness connector (3) on the plastic retainer on the body control module bracket and connect the vehicle body wiring harness connector (2).
  10. Connect the steering column wiring harness connector (1) to the body control module.
  11. Connect the range selector lever cable to the steering column. Range Selector Lever Cable Replacement
  12. If equipped, connect the automatic transmission shift lock control actuator. Automatic Transmission Shift Lock Control Actuator Replacement
  13. Connect the upper intermediate steering shaft to the steering column. Upper Intermediate Steering Shaft Replacement 
  14. Fig 4: Deflector And Nuts
    GM3815569Courtesy of GENERAL MOTORS COMPANY
  15. Install the instrument panel knee bolster deflector (2) and nuts (1) and tighten the nuts to 9 N.m (80 lb in).
  16. Floor Front Air Outlet Duct - Left Side - Install - Floor Front Air Outlet Duct Replacement - Left Side
  17. Instrument Panel Knee Bolster - Install - Instrument Panel Knee Bolster Replacement
  18. Steering Column Shroud - Install - Steering Column Shroud Replacement (Manual Tilt) Steering Column Shroud Replacement (Manual Tilt and Telescope) 
  19. Enable the SIR System. SIR Disabling and Enabling
  20. Relearn the steering angle sensor. Steering Wheel Angle Sensor Centering