Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | |
|
100 N.m (74 lb ft) |
|
75 - 90 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | |
|
22 N.m (16 lb ft) |
|
30 - 45 degrees |
| Front Wheel Bearing and Hub Assembly Bolt | |
|
100 N.m (74 lb ft) |
|
60 - 75 degrees |
| Steering Knuckle Nut@Front Lower Control Arm | |
|
50 N.m (37 lb ft) |
|
Loosen 120 degrees |
|
50 N.m (37 lb ft) |
|
30 - 45 degrees |
| Steering Knuckle Nut@Steering Knuckle | |
|
85 N.m (63 lb ft) |
|
60 - 75 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Front Suspension Strut Mount Nut | 55 N.m (41 lb ft) |
| Front Suspension Strut Nut | 75 N.m (55 lb ft) |