LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Electrical >> Starter >> 12 V Starting And Charging System >> Repair Instructions >> Battery to Fuse Block Cable Replacement >> Installation Procedure

Installation Procedure

  1. GM3684335

    Install the battery to fuse block cable (1).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the battery positive cable to fuse block nut (5) and tighten to 15 N.m (11 lb ft).
  3. Install the body extension wiring harness (2).
    4. NOTE:

    Counterhold the battery positive clamp.

  4. Install the body extension wiring harness bolt (3) and tighten to 9 N.m (80 lb in).
  5. Tighten the battery positive cable nut (4) to 4.5 N.m (40 lb in).
  6. GM3684334

    Install the fuse block cover (2). Install the rear fuse block cover retainers (2) to the fuse block.

  7. Lock the 3 retaining tabs (3) into the battery fuse block cover.
  8. Fold the rear seat back cushion in original position.
  9. Close the left rear door.
  10. Rear Compartment Floor Panel Trim Support - Install
  11. Rear Compartment Floor Panel Trim - Install
  12. Battery Negative Cable Disconnection and Connection  - Connect
scientia non olet · About LEMON Manuals