LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Electrical >> Starter >> 12 V Starting And Charging System >> Repair Instructions >> Battery Negative Cable Replacement >> Removal Procedure

Removal Procedure

  1. Record all of the radio station presets.
  2. Ensure that all lamps and accessories are turned off.
  3. Turn the ignition OFF and remove the ignition key.
  4. Open the rear compartment lid.
  5. Rear Compartment Floor Panel Trim Replacement (Notchback)Rear Compartment Floor Panel Trim Replacement (Hatchback) - Remove
  6. Rear Compartment Floor Panel Trim Support Replacement - Remove
  7. Open the right rear door.
  8. Fold the rear seat back cushion forward to get a better access to the battery.
  9. Battery Negative Cable Disconnection and Connection  - Disconnect
  10. With start/stop system use the following steps:
    1. GM4091412
      NOTE:

      Use a counterholder to prevent the battery sensor from damage.

      Install a open-end spanner (1) to counter-hold the battery sensor as shown in the graphic.

    2. Remove the battery negative cable nut (2).
    3. Battery Negative Cable(3) - Disconnect
    4. GM4091413

      Battery Negative Cable Clip(1) - Unclip[2x]

  11. Without start/stop system use the following steps:
    1. GM4091388

      Loosen the battery negative pole clamp nut (2).

    2. Disconnect the battery negative pole clamp (1).
    3. GM4091410

      Remove body extension current sensor wiring harness to battery negative cable bolt (1).

    4. GM4091389

      Disconnect the battery current sensor connector.(2)

    5. Battery Negative Cable Clip(1) - Unclip[2x]
    6. GM4091391

      Remove the battery negative cable terminal cover (1).

    7. Battery Current Sensor(2) - Remove
scientia non olet · About LEMON Manuals