LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Corvette Z06, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Boot Replacement >> Removal Procedure

Removal Procedure

  1. If servicing the left side steering gear boot, remove the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement (LT1)Air Cleaner Outlet Duct Replacement (LT4)
  2. If servicing the right side steering gear boot, remove the air cleaner assembly. Air Cleaner Assembly Replacement (LT1)Air Cleaner Assembly Replacement (LT4)
  3. Steering Linkage Outer Tie Rod - Remove - Steering Linkage Outer Tie Rod Replacement 
  4. GM3417806

    Steering Linkage Inner Tie Rod Nut(1) - Remove

  5. Steering Gear Boot Outer Clamp(2) - Remove
  6. Partially lower the vehicle.
  7. GM3417807

    From the engine compartment, cut and remove the steering gear boot inner clamp (1).

    DISCARD the clamp.

  8. Raise the vehicle.
  9. Remove the steering gear boot (2) from the steering gear.
  10. After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination.If corrosion or contamination is evident, replace the steering gear. Electric Belt Drive Rack and Pinion Steering Gear Replacement 
scientia non olet · About LEMON Manuals