Installation Procedure
- Inspect the inside of the ignition coil boot for a thin, even coat of dielectric grease. If there is no grease present or additional grease is necessary, continue to the next step.
- Apply a thin coating of dielectric grease to the inside of the ignition coil boot up to a depth of 15 mm (0.60 in) from the end of the boot.
- Remove any excess dielectric grease from around the end of the ignition coil boot and ensure there is not an excessive amount within the boot.
- Install Ignition Coil (2)
- Install Ignition Coil Bolt (1) and tighten 10 N.m (89 lb in)
- Connect Ignition Coil Electrical Connector (1)
- Install Intake Manifold Cover Intake Manifold Cover Replacement
CAUTION:
Refer to Fastener Caution .